Recent content by NotYourName

Here you go. Potmeter in middle ofc.

The camera i fairly easy to remove and re-assemble. 4 screws to get to the circuit-board, and two screws in the circuit-board to get the whole thing out. The only tricky part is to remove/re-attach the ribbon. The ribbon-connector has a little hasp that yo need to lift in order to get the ribbon...

Here`s the camera :)

I think mankind have faced bigger challenges.. Worth a shot. :)

No. It is "fastened" in the arm that holds the next axis. And should be hold on tight.. Sadly it does not.

The "hub" in center of the red circle could need some sort of support (Glue?) so the motor don`t pop open..

I have a gimbal that went haywire after a crash, flicks frenetically in all directions when turned on. As i bought i new one, i have the old one to tinker with.. And yes.. It comes off.. Easily! I am considering to glue the new one.. This is definitely a weak spot. And i have no idea how the...

That sucks man! My gimbal is exactly like that. I crashed though, so i kinda know what to blame. Though my camera did not fall off.. I have tried a lot of different things.. Forced firmware update, Advanced calibration (With clamp on gimbal to keep it steady) dismantled the gimbal completely...

Yes. Tried a forced firmware update as well.

Thanks DrJoe, i`ll try that next time. I got me a smaller drone to practice with. And I have been able to recreate the scenario, excluding "bugs" and finding that the error is indeed me. With some practice on this cheaper variant, I will hopefully make the correct maneuver into a reflection...

Got desperate.. Bought one.. Have dismembered the gimbal twice. Cannot seem to figure out what`s wrong..

During a descent, i rotated the drone 360. Suddenly it started to wobble, it did not react to a ascent, and the following crash was inevitable. The Camera took a blow. Now. When i power on the drone, the gimbal goes haywire. Rotates frenetically in every axis and seems to be suicidal. Dji...