Seems to me that the problem is only with the tablet, that cannot "read" video data sent by the drone. If I record a video, everything is perfectly saved to SD card, but not at N8000.
Debugging is enabled. I tryed to change USB connection options, but nothing changes.
If I push record, video is perfectly recorded in the P4 SD card. But images are all black on N8000 tablet.
I'm not sure but I was thinking about a possible codec missing?
Hi everyone.
I have a Phantom 4 connected to a Samsung Tablet Note 10.1 (N8000) and connected to a Samsung Galaxy S4 (I9505), both using CM13 firmware (Android 6).
When connected to the I9505, all works fine. If I connect to N8000 tablet, the connection status is "Ready to Go", but no camera...
Hi everyone.
I have a Phantom 4 connected to a Samsung Tablet Note 10.1 (N8000) and connected to a Samsung Galaxy S4 (I9505), both using CM13 firmware (Android 6).
When connected to the I9505, all works fine. If I connect to N8000 tablet, the connection status is "Ready to Go", but no camera...
Hi! I'm experiencing the same "Disconnected" issue, but as I can observed, when I plug the USB, android don't display "how to connect" message. I did a full clean install on the tablet and on the DJI Go settings. I tried with DJI Go 3 and 4 version, with no success.
In my case, I have a P4...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.