Recent content by noiep2v

  1. N

    Camera Stabilzer Problem

    Happened to me twice 4 days ago and yesterday. same excact thing, mid flight no wind flying for about 5 mins. No control on tilt and c1 brought it down and cycle it and it was fine. Did a gimbal calibration and test flite it working properly. That's the first time. Second time was yesterday...
  2. N

    Can't get comunication between my P2 and the Remote Control

    Re: Can't get comunication between my P2 and the Remote Cont finally got my p2v back and it was the receiver that was faulty. i was gearing towards that but just to make sure i took it to somebody who is experience in repairing this quad. thanks everybody for the advice i got in this forum.you...
  3. N

    Can't get comunication between my P2 and the Remote Control

    Re: Can't get comunication between my P2 and the Remote Cont i took my p2v two days ago at UAV-RC in west covina to be repaired. they said that they are gearing towards the hardware parts not the software. i was thinking of the receiver thats the problem but just want to be sure,thats why i...
  4. N

    Can't get comunication between my P2 and the Remote Control

    Re: Can't get comunication between my P2 and the Remote Cont Yup, it's current and it passes the calibration on the RC software but fails on the assistant
  5. N

    Can't get comunication between my P2 and the Remote Control

    Re: Can't get comunication between my P2 and the Remote Cont have the same issue but my happened after it crash and pop out battery. i tried rebind it the first time and it did successfully but after i turned it off and put fully charge battery same thing. flashing rapid yellow and when you...
  6. N

    Tx won't bind, rc won't calbrate stuck in failsafe help plea

    after crash about 15 feet. landed on its top ,battery pop out, camera hanging. put it back together, rapid blinking yellow. tried binding it and it did bind but after i shut it off and fully charge battery. started to rapidly blink again.now it won't bind, didn't see any loose connectors or...