Recent content by njet212

  1. N

    Can't upgrade P3 Pro Controller

    I just format my thumb drive and copy P3X_FW_V01.01.0008 and it updating now! I dont know whats going on but hope this post will help someone who have similar problem
  2. N

    Can't upgrade P3 Pro Controller

    Oh i forgot to mention, i already tried using thumb drive. It did not work.
  3. N

    Can't upgrade P3 Pro Controller

    I just upgraded my phantom 3 pro firmware with P3X_FW_V01.01.0006 and the logged file said success. But when i upgrade the remote it just won't do the update, the red led stays red and after wait few mins it keep on the red led and do long D____ D____ D____ After i checked the DJI web...
  4. N

    Bad Video

    Yeah agree with that, i put ND filter 2 stop also on my gopro, it's called polarpro. It's works fine, but it's bit bulkier and about 2 grams heavier than the blurfix filter
  5. N

    Bad Video

    It's usually happen when your camera facing towards the sun, the shadow from the props makes those static effect. It's could be fixed by adding Neutral Density filter, check out video below ( this youtube channel also got lots of tips for gopro and DJI P2 ): BlurFix Air ND Filter fix...
  6. N

    is it possible to use the BlueTooth on a Hero4 on a Phantom

    Re: is it possible to use the BlueTooth on a Hero4 on a Phan edited never mind
  7. N

    Zenmuse H3-3D + GoPro + ND Filter

    I have P2 V1 with H3-3D, Hero 4 black set-up + filter from Polarpro, the one on the picture is Neutral Density, it just plug and play without any modification.
  8. N

    Upgrade for Phantom 2 V1 motor ?

    Oh yeah i was forgot to mention, i'm planning using 9" prop. Im comparing T-Motor spec for thrust on MN2214 motor using T-Motor Anti Gravity 9*3 prop while on Air 350 is using T-Motor plastic 9545 prop. On 100% throttle Air 350 motors with plastic 9545 props provide more thrust and more rpm (...
  9. N

    is it possible to use the BlueTooth on a Hero4 on a Phantom

    Re: is it possible to use the BlueTooth on a Hero4 on a Phan Don't use GoPro Wifi when flying your Phantom! it will cause crash or flyaway, unless you'are upgrading your radio system with dragonlink and fly manually turning on your GoPro wifi will not interference with your system
  10. N

    Beginner Guide ???

    Oh yeah i was the same at you last month when first time i got this drone, very unfamiliar R/C terms which makes me headache. For the beginning, you might want to check the playlist video below ( this is the most important thing you want to know to avoid crash and flyaway ) It's mostly explain...
  11. N

    Can you clear up my confusion?

    See this page from one of the phantom dealer, they give side to side whats new on V2 compared with V1
  12. N

    Upgrade for Phantom 2 V1 motor ?

    Thanks cityzen, the different from spec is Air 350 have more trust for each motor compared with Anti Gravity MN2214 which i suspect will be more powerful with less flight time
  13. N

    Gimbal suddenly moves with the lefts sticks in pan axis

    Connect your Phantom to your PC and open the PT2 assistant sofware, then go to Advance tab, choose gimbal. Make sure unchecked the FPV mode. Your gimbal now should always maintain level
  14. N

    New firmware and new owner questions!

    After enabled Naza mode, make sure your phantom got GPS signal otherwise you can't activated IOC
  15. N

    Upgrade for Phantom 2 V1 motor ?

    So i'm about to get set of motors for my P2 V1, i'm stuck between T-Motor Anti Gravity MN2214 and T-Motor Air Gear 350 package. The MN2214 does look compatible because it's made for P2 upgrade, but not sure with Air 350, beacuse the ESC is without BEC. Do you guys know's if the Air 350 will...