Recent content by nikf

How one can verify that camera is out of focus?? Did you attempt fixing by adjusting the camera board height or by turning the lense? (i have a p3s) It would be nice to get some before and after examples in a single post since this issue affects a huge amount of phantom 3 (sending in to DJI for...

So this actually can explain why interference has a different effect for everyone right? I also thought that the channel will be changed during flight if there is much interference. But it seems that if you take off from a low interference spot and head to a higher in theory the channel...

If someone is more familiar with drone footage.. how likely is it that the camera is out of focus? Sent from my Nexus 7 using PhantomPilots mobile app

I have bought the neewer 4 pack filters (the slide on version with UV, cpl, nd16, nd2-400) for quite a while but I can still not determine about the quality of them (since I have no others to compare against). Truth is that despite tight budget, I would spend more money on filters if someone...

Thanks for the comments.. The reason i am asking is because i have the impression that this defect is getting worse and i think comes from a defective gimbal protector. So i wanna just verify first that there is sth obviously wrong. Secondly it is fairly new so not being able to get straight...

I think I also have a bent part on the gimbal! When I adjust the tilt within the app, It does not adjust to the left or right but also a bit up and down!? My question is could it be the dji gimbal protector? Keeping it in the wrong position thus forcing it to bend? Did you also use it? Sent...

Could you please comment on the following pictures? I have the impression that my horizon issue comes from hardware not being straight! Thank you in advance! Sent from my Nexus 7 using PhantomPilots mobile app

Could someone guide me on how to connect via (android) telnet in order to check (while on ground with dji app open and home point recorded) if the 27dbm mode rc only is working? I also have the channel 13 to 1 mod. Does turning off the remote and again on emulates the reconnection issues...

I had the impression that so far this was not an issue - dji go app cancelling the FCC as soon as home point recorded! I just applied the mod yesterday but no chance to test it until next week.. Is there an easy way checking the 27dbm rc only beside actual flying?

Drones in GB are going to be FCC certified? No need to mod..

Hey would u mind sharing some details? Despite flying in Bavaria just for fun I never searched the pros and cons of getting a commercial certification. Where did u apply for this?

I do not yet feel comfortable to perform such a mod since i have no programming experience, but my question is how can you people check the quality of the channels or which wifi channel is used? I never have seen this tab in the dji go app where it shows all the wifi channels, the quality and...

Just a small comment.. without meant to interfere with the thread's topic but going through all the photos one can really observe different quality(details level) from the same piece of hardware. How is it possible?

hey i am also interested into purchasing the standard filters. Beside the loose fitting fisherking described (as far as i get it just defective product) do u have any other comments? build Quality/ video quality/ extra load for the gimbal??

Hi.. I was wondering how one can analyse the .dat file! I know it is more enriched that the .txt file saved on the device after flight, but beside sending to DJI is there a way to extract the data for personal use?