Recent content by nick4594

OK yea will do.

Weather was perfect , sunny with few clouds. About 60 to 62 degrees. Wind less than 3mph

Props are mixed up. Don't have a spare. I'll buy a balance and see if balancing them fixes the issue.

An out of balance prop would be on and off shaking/vibration?

I noticed while out flying today while I was hovering the aircraft in front of me the whole aircraft was shaking pretty hard, like a heavy vibration. After a while it would slow down and come back periodically. Whole aircraft is new with only just a few flights and never a collision. Props in...

Started my phantom up and hovered about 5 ft off ground for a second then all of a sudden this error came up and my phantom started drifting around. I guess it switched to atti mode. I did a hand catch land and calibrated the compass right after. Only had a few minutes of battery remaining after...

i was seeing at around 45 seconds the trees as i was ascending were starting to wiggle side to side. I'm not sure what would be different in how i saved the file and uploaded it, i do the same procedure each time. i just upload it to my mac straight from my sd. the others have turned out fine...

As the title says I'm having some jello issues and its a little annoying. This phantom is only a week old bought brand new. 5 flights total and some prior vids i have taken have no jello or almost unnoticeable. yet today the yellow is very evident. looked up some fixes and i found some things...

I calibrated the compass because the problem happened on first flight and i wanted to make sure something wasn't wrong and see if it does it again. not just try and forget it ever happened. gotta make sure its not doing it every time. Calibrated today and nothing screwed up, will keep monitoring it.

no i will try that though

UAV is Stored in my closet at room temp with props off. I wait til "Aircraft warming up" has gone away. Then start my calibration.

Yea, it always works the second time so i know its in a good location.

It has happened twice now I will power up the aircraft and rc, and app says everything is good to go. I will start the compass calibration, then as soon as i get done with the 2nd 360, back lights turn red and says it needs a firmware update. Knowing that this cannot be i will power down...

Thank you!

Do i need to reinstall the firmware for each sd I will be using with the p3s or does it store the firmware elsewhere in the phantom?