Recent content by natscape

You can easily get the legs out of the frame by using an after market landing gear with a wider stance. As for the arms, you have to either limit your forward elevator input or you can try to move the gimbal around to get the best position. But for the Phantom's size, you have very little to...

I think the "trick" mentioned is for people who use a gimbal. Hard mounted, it's easy to keep the props and legs out of the frame even in wide angle mode.

Some guys over at RCG guess that DJI will be coming out with a Phantom 2 Vision Pro which will have an H3-2D or better gimbal. Guess we'll just have to wait and see.

As far as I can remember GPS and ATTI works ok. I only spent a few minutes trying out the Phantom TX-RX on the Naza M Lite. I switched back right away to the FrSky RX once I saw that I cannot assign a function to the 3rd position of the GPS-ATTI-ATTI switch. I am also quite sure turning off...

Tried it. The GPS/ATTI/ATTI switch doesn't work properly. You cannot assign the 3rd/lowest position to anything in naza m lite assistant.

What FC will yo be using?

Also on 4.02 and Phantom hovers nicely on GPS mode. No difference from 4.00 or 3.16.

But the beeps come from the motors, so it means there's power going into the ESC and motor. Most probably 1 or more ESCs either failed or not getting any power. Listen to each motor one by one and check which motor does not beep.

Re: Lost control of turning and forward, up-down still worke Sounds like the 4.00 geofence bug. Update your firmware to 4.02. Sent from my iPhone using Tapatalk

If you're considering getting a gimbal, better just go for a gimbal instead of the anti-vibe mount.

It's all in the manual. 2 Yellow = sticks not centered 3 reds = No GPS satellite lock

Wind and momentum will tilt the camera during flight. These factors require motors to compensate. Sent from my iPhone using Tapatalk - now Free

So at 300C it would be hot enough to melt the lead free solder that DJI used? Sent from my iPhone using Tapatalk - now Free

Careful when choosing bearing oil. I bought the very expensive boca bearings lightning lube, applied 1-2 drops to each bearing. After a few hours cracks appeared on the motor mounts emanating from the screw holes. I did not use loctite or overtightened the hex screws. It seems that the...

+1. I would also like to know this. :)