Recent content by mlees

Can anyone recommend a 3 axis gimbal besides the zenmuse h3-3d gimbal? Is there anything else comparable or better to use with a gopro 3 and phantom 1?

http://youtu.be/subMB-IQU90

Have you connected to the module and set the panning parameters? If not, this is most likely your issue. I'm not sure off hand if it is F1 or F2 off hand. I'm sure someone on here knows. If you don't get an answer I will pull mine open and check. I think I googled stella gimbal install on...

great video comebackkid!

Are there currently any rules or regulations governing quad copter flight in usa? If so can you describe or point me to some resources?

Hi Robfern, This gimbal is more straight forward than others i've seen, but still not straight forward. When looking at the pin configuration you will use the 1st vertical row of three pins for gimbal control the second vertical row will be unused the third row will be for video if you choose...

Sorry for the delayed response - Its GPB. Settings: protunes - off per suggestions on forum 1080@60 though I think I could have got less grains with 30fps I think WB was raw unless raw is unavailable when protunes is off then I was using auto. Edited in imovie - I did tweak some of the...

http://youtu.be/5ProKH1y-CI

I did figure this out btw sorry for late response. let me know if you still need info. I can update if you still need help, and when I get back to my house

thanks all!

Thanks EMCsquare. Should the first set of gains be set uniformly IE should they all be set to 150%? Where do I find the settings for the second set of gains ie ATTI gains?

Hi All, When I ascend fast there is a noticeable shimmy or jiggle in my drone. I have a v1.1.1 with vision 2 props. I have adjusted gain to 150% and hovering/maneuvering is silky smooth, but when I ascend fast there is a jiggle which negatively effects video. Is there a way to correct this or...

Is there a way to slow down the yaw rate of a phantom v 1.1.1? I would like more fine tuning control of yaw rate and I have no need to spin quickly. I would like a slow rate so when I move the stick to the limit yaw rate is still slow.

thx. I had a feeling that there could be some noticeable differences and wanted to be prepared since I will be very remote. I am fairly familiar with principles of aerodynamics, and noticed a huge change using vision props on a v1.1 requiring gain adjustment. thanks for the tips -

thanks! - I was referring to 10,000-14,000 above sea level. Still probably only a few hundred feet above ground level though just like the link you included thx...