Recent content by mkaiserco

If you're looking for a mint condition Spark, check out my classified ad at sparkpilots.zone.

Here's a followup to my post yesterday . . . Today I tried again and had no loss of signal. Nothing was different other than I started further away from my house than yesterday. Maybe yesterday the iPhone briefly hopped onto my home Wi-Fi network and left the Vision. Today the Vision was...

I took my Vision out this morning for its first flight. I've had a Phantom 1 for only about four months so far, but I've been very impressed with its range . . . the Phantom 1, that is. As suggested, I did adjust the Vision's controller potentiometer before flying, and confirmed the change...

Many thanks to all who have replied. I'll try your suggestions later today or tomorrow and will report back. Mike

Nobody?

When I first got my Phantom, I was able to perform the calibration procedure (switch control mode switch quickly 10 times, rotate on horizontal axis, rotate on vertical axis) just fine. I remember it didn't go into the calibration mode (LED goes solid yellow) the first time I switched 10 times...