Recent content by Mike1390

  1. M

    Install Zenmuse Phantom v1.2.1

    I thought the 1.2 came with an upgrade board, why else would it have the gimbal pitch on the controller?
  2. M

    Zenmuse H2 3D on Phantom Vision

    http://instagram.com/p/godnFhCF0e/ the guys over at dronefly are doing it I guess.
  3. M

    Install Zenmuse Phantom v1.2.1

    nope you should be good. 1.2 comes with the upgrade board.
  4. M

    Installation service in Palo Alto or SF?

    Pay for shipping I'll do it for $50. I'm in the LA area.
  5. M

    Wanted BROKEN GOPRO HERO 3 BLack or silver

    I have a water damaged black edition Dont know the extent of the damage but i let it sit in rice after the incident. The lights turn on but nothing shows on the LCD screen on the front. $250obo.
  6. M

    New gimbal problems

    looks like your zenmuse is bad.
  7. M

    New gimbal problems

    any chance you can post a video of your gimbal start up?
  8. M

    New gimbal problems

    Is your Gopro fully charged before putting it on the gimbal? Just to be clear your issue is that your gopro is malfunctioning? or is the gimbal not turning on?
  9. M

    Malibu Surf video

    Hahah gotcha no I was just south of Leo Carrillo.
  10. M

    Looking for used Phantom

    Look on craiglist couple of phantoms being sold in the LA area right now.
  11. M

    Malibu Surf video

    Are you asking if I'm sure I was in Malibu?
  12. M

    Malibu Surf video

    ahhh could have gotten her closer :lol:
  13. M

    Malibu Surf video

    http://youtu.be/AMDrayXCZ98 Just got done with this. Took the phantom out to Malibu this weekend and put these clips together. Enjoy!
  14. M

    zenmuse. upgrade board. mac computer. go pro only faces down

    Re: zenmuse. upgrade board. mac computer. go pro only faces my upgrade board came with 3.14 not 4.0
  15. M

    Zenmuse + upgrade board+ 5.8 downlink wiring finished.

    Alight guys I picked up my 5.8 DJI downlink today and after some serious soldering, and tinkering I figured it out. Step one take the transmitter wire and strip it and cut in half just below where the 8pin and battery split into 2. You should now see a multitude of wires...