Recent content by mickybobby

Tried a firmware yesterday and it just sat there flashing green/red like it was updating for about 1 minute and then started flashing green quickly for about 1 minute. I checked for a log file and there was nothing there. It must be writing to the SD card though because it creates a DCIM folder...

So in the DJI go app it shows full bars for reception on both the RC and Video bars. Also there is activity when you go to settings to check the channels to use for video streaming. Would this still be there if the OFDM failed. Or could it be a case of just a certain chip on the OFDM board failing?

Thanks for the replies quaddamage. I just want to confirm that the ribbon cable I replaced is the one that connects the camera to the gimbal top board. I did also change the cable that connects the top board to the OFDM module but that had no change. Also I can't read from the SD card via usb...

I replaced it with a whole camera and the gimbal top board.

Hi everyone! So I have spent a few hours going through threads trying to see if anyone else has experienced this problem and I can't seem to find anything. I have a P3 Pro and everything was working fine up until I replaced the camera housing. I now have no video feed and no camera control at...