Recent content by michalip

Just wanted to add that over the past year when I had faced similar issues I resolved once by disabling every other app on my android device, another time by upgrading the app(many months back) and a week ago aftee realizing my original usb cable was pinched....replaced with a samsungs usb...

hi, Any comments in the issues with short range or image cutting out or were those only related to the APP version and not linked to FW versions? I'm still on 1.6 and APP 2.4.1 I believe

well my bad it seems I'll test it out tomorrow , had one successful flight with it already . I understand its a risk but it seems i ll take it for now and keep an eye on it

here's the thread P3 Increased Battery Performance

Yep, let me try to find that thread and link it

hi, Just wanted to report a couple of things I noticed after deep cycle/discharging my battery , down to 2% as per forum recommendations. As I was reaching around 25 and 35 battery cycles on my two batteries, I decided it was time for a deep cycle. I had a small deviation on the cells voltage...

Here's my story on the 1.6 upgrade. was on 1.5 and started doing the upgrade for 1.6. Then I noticed it was stuck on the red LED for an abnormally long time. I gave it a few more minutes and then I stopped it. Checked the status and it said that it failed and to retry. I retried but it wouldnt...

hi, If I go to a site and return with batteries at 40%,I let them sit until next weekend and charge them up If I come back from a site and they have 20-30% then I just charge them up the same day ...I just dont like to leave batteries on low or high charge for extended period of times which is...

Just saw this thread , and had to check because this was disturbing and seems unsafe. I had upgraded last week to 1.5. Without flying this week at all. Tonight I set the bird on the table and didnt notice any vibration from any of the motors or gimbal. I do remember last week doing Android...

Yup, just confirmed it, the C2 default action Good to know finally, I guess I should read the manual more often and be more careful on the key associations

Had this exact problem and searching through the forum led me here. It was puzzling for me because in 100+ flights it happened in only 2-3 of them, so it was over a long period of time with many & different FW updates and different locations . I always thought it was random interference because...

I've ordered the TK102B. Have good experience from the same brand ( got a 6600ma battery one for my motorbike...and that works well) , so it was a no-brainer for me. Hopefully this one does the job as well. Apparently the battery lasts for 6d or so but since the unit will be on for only...

thanks for your replies, general consensus is that it wont work , but if anyone was brave enough to try it -- let me know

I was asking this as well, but it is still unanswered as to why it wont fit the H2. Physically it fits, front back everything can be made to fit - no issue. The question is about power/signal/pins and weight calibration so basically what I m lookin for is if someone has tried it already.

hello what does the above actually mean ? calibrated? can someone plug the hero2 on the zenmuse or not? Anyone tried?