Recent content by Masonmedia

  1. Masonmedia

    Controller FW update

    Anyone else getting the "firmware needs updtaing" repeatedly for the p3p controller? It happens to me randomly over and over every since the 1.8 (bird) and 1.6 (RX) update. One time it'll be fine (the rx) and updated. The next time it says it needs to be updated. So I'll update it again. Then...
  2. Masonmedia

    P3 pro update to 1.08

    I had a similar issue updating. Finally got it to take but every since I've been getting the "firmware needs updtaing" repeatedly for the p3p controller? It happens to me randomly over and over every since the 1.8 (bird) and 1.6 (RX) update. Anyone else?
  3. Masonmedia

    P3 pro update to 1.08

    OK, I finally got it guys thanks. The beeping just threw me as thats never happens. I just put in some ear plugs and let her rip and it finally updated. Thanks for the help.
  4. Masonmedia

    P3 pro update to 1.08

    Ok thanks, maybe I just didn't give it long enough. I'll give it another shot...wow. this beeping hurts my ears and scares the crap out of my dogs..lol
  5. Masonmedia

    P3 pro update to 1.08

    Right, thats what normally happens. In this case it never stopped. The .txt file also said success. Also, the loud beeping is coming from the phantom, not the normal beeping you hear during an update so it kind of spooked me. I assumed the update had failed but the .txt file suggests otherwise.
  6. Masonmedia

    P3 pro update to 1.08

    it said success. Problem is this is what it is doing continuously even when trying to connect to the RC and app as if I was going to fly.
  7. Masonmedia

    P3 pro update to 1.08

    And now to this.
  8. Masonmedia

    P3 pro update to 1.08

    So. The first try I got a flashing red red light on the gimble that never changed. The memory card file said success. But I decided I should try to update again just to be safe. This time I got this. Any ideas?
  9. Masonmedia

    FAA 333

    I just got mine back as well. Unfortunately, I didn't know because I never got an email and it hadn't been posted. It only showed a comment that I couldn't view. I called and they posted it and I was approved. Not sure if that's good or bad. lol
  10. Masonmedia

    Section 333 Exemption, how long for approval?

    I completed my paper work Sept. 7. It hit the docket on regulations.gov on Nov. 18. Just received the decision today and it was dated March 3.
  11. Masonmedia

    Vibration while hovering

    Where are you located Bruce? Sounds like my situation. I'm north of Nashville. Just had a snow storm etc... Again, most/all of this was pre-flight and during the warm up hovering then it settled down. I always calibrate the compass b4 every flight.
  12. Masonmedia

    Vibration while hovering

    I haven't personally balanced the props but I also have not had an issue. Again, the vibration settled down after hovering for a couple of minutes.
  13. Masonmedia

    Vibration while hovering

    No visible moisture in the air and the sun was shining finally melting a little of the snow here.
  14. Masonmedia

    Vibration while hovering

    I had just calibrated both IMU and compass but recalibrated anyway just to be safe. What do you mean by MOD values?
  15. Masonmedia

    Vibration while hovering

    Yea, it was when I first took off while hovering and actually settled down before I went any further.