OK so Iv'e done a few flights now mainly staying close and just stooging about.
This is my first real sortie. It's also my first attempt at putting a video together. I used iMovie for this and it seems to have done a reasonable job. I need to lengthen the transitions as they are a little abrupt...
I must admit that I have not looked at the bottom of these DJI motors.
But saying that they should be the same as any other RC motor of this type.
If so once removed you should see a small circlip on the bottom of the motor on the shaft. Remove this circlip and the outer bell will simply pull...
I work offshore so fly in helicopters all the time.
They always lift off and hover between 5 and 15 feet before dropping the nose and powering away.
Its something to do with ground effect and building a cushion of air.
Mark.
Unfortunately Google translate doesn't do Scottish.
Thankfully I sometimes work in Scotland and even though I am a guffie b**tard I could understand every word :D.
To answer your question, it is probably a lot less than you might think bearing in mind how many of these things DJI has sold.
Mark.
Thank you for your help guys.
I understand the problem now.
I will try the exfat route first but if that doesn't work I think we have iMovie on our Mac which might enable me to add the files together. It's been put away while we redecorate at the moment!
Best regards.
Mark.
Hi Guys.
I did my first "proper" flight today. Up round our local lighthouse and then along the North Norfolk coast.
All went well but instead of one file with the entire flight it was split into four files! No two files are the same size. The record button was pressed at the start and end of...
Why do you keep whining on this forum? No one here is going to give you a new shell or motors.
Keep complaining to DJI and when they have resolved your issue (good luck with that by the way) come back and let us all know how you got on.
Mark.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.