Yes you can.
I have it.
It will then support other batteries besides the P2 standard batteries, it will NOT HAVE the No Fly Zones restriction (depending on FW version (mine does not have it) and you will loose the LED behaveour underthe arms..
So... Install it and then use the LED from phantom...
NAZA-M V2 is NOT the NAZA-PHANTOM
Although the hardware may be the same, you will loose not only the LED functionality on the ESCs (still to try fitting the Phantom Fc40 LED to see if it works.. it's handy on the compass calibration) but also the percentage of remaining battery indicator on...
Hello all.
I have a Phantom FC40.
I don't use the FC40 camera anymore, replaced it with a gimbal and a Mobius Actioncam.
No.. I would like to have FPV and telemetry on this.
I know I can add an FPV 2.4GHz Rx/TX and have the FPV... but I need telemetry.
What do I need to have it...
Wobbly descents:
People had answered already.
About loops and rolls:
You can enable manual mode in the NazaM V2 assistant software.
Put in the third (down) position of the right switch.
Then, takeoff with GPS get some high and SET THE HOME POINT somewhere like 20/25 meters high or more...
Still no wifi signal.
The card is a 16Gb card, class 10 and it has worked before.
The wifi SSID was always recognized by the Android devices I use as well as by the PC...
Suddenly the camera's wifi stopped broadcasting.
It starts flashing green, the it stops, led off. then start again...
Hello.
All of the sudden I found my FC40 camera wifi signal not showing anywhere.
When I power up the camera, the led starts flashing but I cannot see the SSID on none f my WIFI enabled devices.
Looks like my cam's wifi had died...
Any one had this problem before?
Thanks
Fernando
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.