Recent content by Madkeen

Hi Started an advanced calibration and it will not finish. Got to about 90% and just hangs. After about an hour I gave up and turned everything off and started again. Same thing happens. What can I do?

The added maximum height and radius limits bother me. I fly mainly in Vietnam and there is no maximum height issues. If I update will I only be able to fly to a maximum of 400feet ???? Or does that only apply to flying in the USA with the ground station??? I take a lot of footage at 400 to 600...

With the opposition already on drones the last thing we need is the news reporting of someone loosing an eye to a drone or serious facial injury, etc, etc..... Would set us back another few years. Think about the consequences of your actions. These things can and do go wrong.

You need to upgrade the firmware. Plug you cable directly into the IOSD mini and use the IOSD mini program. Run the update and you will be fine.

Thanks for all your effort to fix this. Hopefully DJI will listen, but will not hold my breath. I never noticed this problem when I was flying in Nha Trang, Vietnam. Not that I was looking for it either. But I will be back there in 2 weeks so will check it out

Have tried it with the gopro On, off and completely removed. Makes no difference. Still have the issue.

Yes, looks like it is all the way in. Hope the new one arrives soon and fixes the problem.

I like the color in the second one. If the photo is for displaying in the store only I would use the second one. If the photo was to be used on the website I would use the first one as it gives you an idea of the where the store is. You get to see the traffic lights on the corner at the...

I had a similar problem, just needed to plug the connector in an extra millimeter and everything worked.

Have you made sure the 8 pin connector is plugged in all the way. It may not quite be plugged in far enough. Or sitting a bit crooked.

Have you tried calibrating the camera tilt leverin the assistant software? Need to do that especially after an upgrade

Yes, has this J hook issue today. Haven't tried anything to fix it. Seems to be in first fe minutes of flight. I am in Brisbane Australia. So doubt it is a location issue

I was about 100ft from the wheel with my back to it and the Phamtom was about 100 feet in front of me and about 300 feet high. So the wheel was not between the phantom and me. I looked around and could only see a pad mounted electricity transformer. A TV station offices are there as well but...

Get a dril bit the size of the screw head and drill the head off. Careful not to drill any of the plastic. Then when you open the housing you will be able to get a pair of pliers on to the bit left of the screw that is sticking out of the plastic.

Have had two instances in the last two days where I have lost control of my phantom. One resulted in a crash and one I got control back after a fair length of time. Is there anything out there that can scan and show if there is any signal that may interfere. Would be great to monitor an area...