I set my Go app to imperial measurements. Flight data on camera view is feet and mph but flight envenlope controls are still in meters. On the RTH altitude I thought 200 feet would be fine for my area. Little worrisome when it went to over 600 feet (200 meters) before heading towards me.
I see a lot of this issue on loss of a prop. It's frustrating that Dji hasn't addressed it. Are the threads on the motors metal? Are the hub threads metal? How tight is tight? How about a special torque wrench?
Sorry for your loss.
Update.
Plugged into usb wall adaptor.
Controller off, red status light is lit. Green level indicators are not lit. Waited 2 hours. Status light turned green. Turned on controller, battery fully charged.
Good to go.
Just getting my P3S out of the box. Noticed the dampeners are not the same. Two have what appears as some sort of fastening plug on top and bottom of the dampener, two do not have them. Is this normal?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.