Recent content by linux2ex

the topic is old, but maybe it will help a friend. ipad 4th generation device 10.3.4 version to install the new dji go software. http://www.3u.com/ Download the software from this link and do the operations on the video. This is how I use dji go on ipad4.

https://www.waveshare.com/wiki/PL2303_USB_UART_Board_(mini) With the help of the Prolific PL2303 USB-TTL serial converter card, you can operate the gps using the u-centersetup_v8.13 software from the computer.

You can look at this link. have information on the gps ends. https://github.com/o-gs/dji-hardware-schematics/blob/master/phantom_3_pro_esc_center_board/phantom_3_pro_esc_center_board.pdf

1,2,4,5,6,7 Does anyone know the connections of the feet? I tried to ignore my reports.

the device finally worked. As I wrote in my previous messages, m2 vcc part and m1 R part are connected. It was the right one. the front and back lights must be lit. My current problem was that the device could not detect the GPS. The EPROM on the GPS (25QDVSIG) is broken when the device is...

only the m3 and m4 sections are linked in the schematic. The m1 and m2 sections have different connections. this can be seen in the picture I have shared before. It is very different from the schematic. my English is not good. I'm using google translate. I am sorry if wrong.

Is there a friend who can measure voltages at vcc, r, g, tips at the esc terminal? Volts of m1, m2, m3 and m4 sections? m1 section (R), m2 section (VCC) tip, short circuit? I am having problems with this part. insoluble.

Thank you for your interest. I will make checks and give information.

hi, problem, LEDs are not working. there is no 12v on the vcc line in the front left section. front right and back led vcc have 12v on the part. I wrote the voltages in the picture. front left vcc part and R right short-circuit in front right part.

Thank you for your interest. I'm sorry for the loss of p3p. The p4 on the way to your table is gratifying. you use hope without any problems. I do not know english. Google Translate. If there is a typing error, sorry.

hi, the subject is old but may be needed by other friends. I have a linkte schema. The 5v line was defective in my device. + the batt line was lit by the capacitor. this section has been cleared. capacitors were added. tps54531 pin3 connected, 12k resistor defective changed. pin3 measured...