Recent content by Kube

Thanks, This was very helpful..

Thanks, I believe you are right. It changes drastically when I tap the screen to set the exposure. I will study the app and see how to turn that feature on or off. How do you control exposure? The dial on the remote or by tapping the screen in different locations to get the best looking color?

Does anyone know why I started to get black and white lines on my iPhone FPV? Sometimes it is throughout the entire screen during transmission and sometimes just around the edges. It just started doing this on its own. Ive only had my Phantom 3 Advantage for 3 days! First 5 or 6 flights I did...

Thanks. I ended flashing the flight controller a second time and the the gimbal works perfectly now.

Mine goes just above center. It definitely sees the props if I take that far up. It will also point straight down or just shy of it.

I flashed the controller a second time and my gimbal dial now works great the camera stays at the pitch I want. Have not tried to calibrate the compass yet. I do have a brand new compass landing leg I will install next if it does not calibrate right next time I try.

Yes. Multiple times. I had to unplug the gimbal and turn off the camera to get a successful calibration.

I did the same. My gimbal now does not hold position. When I lower it and let off the gimbal dial it will raise back up on it's own.. I still get red lights when calibrating the compass.

I reinstalled the firmware. I still get the red flashing lights when I calibrate. Also the camera rotates back up after I adjust it to point down some so I do not see the prop guards. Is that a setting?

Did you jump F1and F2 then wipe the controller and leave the jumper plugged in while you installed the firmware like the video or did you wipe the controller then shut down the phantom unplug the jumper, plug the gimbal cable back into F1 then restart and install the new firmware? I'm concerned...

I can email the video. Would need your email address. I watched the video you sent. The wiring is different on my P2V. Their is a plug in the F1 slot. Can I just unplug it to wipe it with the jumper cable then plug it back in to rewrite the firmware?

Well the video was to big of a file. I basically removed the wires out of the camera. Installed new 12" long wires the same gauge as the ones I removed. Drilled a hole out the back of the camera for the wires to pass through. Shaped the wires into springs by wrapping them around a small shaft of...

Here is a video of how I successfully added the 2.4GHz pinwheel antennas to the phantom without restricting the gimbal movement.

Can you send a link to the video? I will do a hard reset. I just put a new control board in the Phantom and updated to 3.12 a few weeks ago. Have not upgraded to 3.14. Just this morning I calibrated using the computer software. Now I do not get the warning I need to calibrate when I am getting...

Yes I get continuous red lights but cannot calibrate unless I unplug the gimbal first. I am running 3.12