So I crashed my Phantom. Suddenly flipped over and tumbled to the ground. I was very happy with it except for the gimbal tilt function I never got working with the original transmitter. So I decided to remove all the parts from the wreckage and for now replace the speed controllers and radio...
Thanks,
I actually opened the TX and turned the pot by hand to be sure.
My phantom says v. 1.1 on the bottom (I presume that is P1 1.1...?) I will check for a USB connection on the TX when I get home. Can´t remember seeing one though..
The Tarot is working pretty well at the moment, although...
First of all: Thank you so much for taking time to advice me on this. I have tried that now: signal from F2 to T on the Tarot and negative pole on F2 to "-" on the S row. (tried the negative on P row as well - even connected both positive and negative there and realised the Tarot could be...
Yes, I am using the stock transmitter and receiver. My Phantom says v 1.1 My receiver has 2 three-lead connectors going to the X1 and X2 ports on the Naza (see bad photo ;) )
It seems to me like the wiring is correct - and the channel is marked as "ON" in the assistant. But no signal registers when i turn the knob in the transmitter...
The potentiometer did get a little squeezed when I first tried to attach a home made lever to it. But it seems to have all 3...
OK. I opened it up again and my description was a bit off. I have the signal lead from the F2 port on the Naza connected to the "T" in the "CTR" connections on the Tarot. I have a cable from the main board (just where the battery connects) to power the Tarot. Do I need an additional ground...
Thanks a bunch!
I don´t have the Phantom here now - and it has been a few weeks since I opened it up so I am a bit vague on the connections. Will have another look and try to make sense of this thing :)
Hmmm. No. I thought it was just a matter of connecting the X1 to the tilt signal input on the Tarot.. Anyway - in the assistant I get signals from the four flight controls, but nothing from the X1
Thanks for your input. I was a little confused about the different versions. When I bought this, there was only one option. It was called the DJI Phantom ;)
I am trying to control my Tarot gimbal with the X1 channel. But so far I have not been able to activate that channel in the assistant...
Hi,
I am trying to activate the tilt function on my Phantom 1 - now running FW 3.04 After a lot of fiddling with it, I found out on this forum that the function doesn´t work on anything above 2.0 (WHY??) I have downloaded the Assistant version 1.08, but can´t find the firmware... The Assistant...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.