Recent content by KISA

Thanks again Jerry. I actually have the SimpleBGC software and have used it to calibrate the board previously, before posting here, which I think was, hold the gimbal in place and press calibrate, then it locks in that place. So I'll do the roll part again just to get it spot on. Thanks for the...

Worked perfectly, thank you very much for that :). Is it possible to connect the second wire to fine tune the roll. I assume Bottom pin, F1 is the roll pin? Though I did notice there is no tuning option in the RC Assistant?

Thanks Mark. I understand that, but the frequency is just the carrier, the data itself (i.e. control information) should still be the same.

Thank you very much for the detailed explanation, I'll double check my wire connection and run through your steps. Will let you know how it goes.

Thanks. I assume there is, but they do have what appears visually to be the same NAZA-M V2 as the top video shows, with the same pin outs, so I assume it's possible. I expect the differences will be mainly firmware, with the vision + still having the capability to send control signals from the...

Yes, it was already set to Upgrade Controller.

Hi, I've acquired a second P2V+ with a smashed camera, as well as a FPV 2 Axis Gimbal (http://www.banggood.com/FPV-2-Axis-Brushless-Gimbal-With-Controller-For-DJI-Phantom-GoPro-3-p-908068.html). So I thought I modify the P2V+ to use a GoPro. I've installed the gimbal, configured it using the...