Recent content by KarnerBlue32

Thanks, Oso, for the OEM link. I have not tried this particular cable, but I believe the reason for my gimbal acting worse than before I switched it out is my fault. I didn't sit the cable back far enough and now it's rubbing while it moves. Honestly, the sticky points are already coming off and...

Once I changed the cable and still did not have any status indicator light on the front of the aircraft, I contacted DJI online support. They suggested I send it in for further diagnostics. Sad day, it still hasn't even seen any airtime!:persevere:

I bought the one off Amazon that msinger suggested above.

I replaced the ribbon cable and the status indicator light still does not light up. Plus, the gimbal is moving worse than before. Now it won't even look straight ahead at power up; it acts like it can't lift up all the way. I'm so frustrated at this point. Any other suggestions before asking DJI...

To my knowledge it appears that the ribbon cable is fully seated so I have placed an order for a new one. I will reply to this thread once I've replaced it and tried updating again. Thank you for your assistance so far!

msinger- Yes, the gimbal does still drop without the memory card installed. I don't see any difference in gimbal behavior or light patterns when it is in versus when it is out. I have tried installing the latest three P3P firmware versions a few times each with the single BIN file being the...

Not that I am aware of; it hasn't even been outside the building. My supervisor acquired it from Buydig.com Sept 2016, he handed it over to me sometime in November, then it sat either in the box or on my desk untouched for several months until I started reading/watching videos about getting...

Hi, I'm also a newbie and attempting to update my new P3P drone and have been unsuccessful for a few weeks now. It was purchased back in the fall of 2016 but I wanted to obtain my Remote pilot license first before flying. Now that I have the license, I can't seem to get the drone and controller...