I appreciate your time. I have spent about six hours of my time on this when I would rather be working on something else. I will give the drones back to my friend to take to a local dealer for repair. I gave it my best. I am an RF electrical engineer and enjoy working on hardware. I hate...
I also pressed the reset button while powering up the aircraft as is shown in the video instructions. The gimbal goes through its motions, goes limp and the aircraft just keeps going beep beep, beep beep, etc. It never concludes nor does it write a txt file to the SD card. Firmware!!!
yes, it sounds a lot like my issue with the same frustration. I have been trying to install a downgraded FW load but still no resolution. It never goes into the FW upgrade mode according to the beeps. Just the two beeps. They go forever. The DJI Go app said that the aircraft had FW version...
The gimbal moves in the beginning for about one minute before it goes limp and stays that way.
I have the bin file in the SD card in the aircraft with the remote turned off just like the instructions state. There are no other files in the SD card except for some empty folders (DCIM and the...
I have found similar threads but no solutions so far. I am trying to fix my friend's P3 Pro. He updated the FW to 1.6.0040 in the aircraft by following the DJI instructions but now the gimbal is limp and there is no video. The drone can still fly.
On the DJI Go app, About Screen, the aircraft...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.