Recent content by jzibble

  1. J

    Phantom 2 radio in a Phantom 1?

    I finally got it working. It was weird. I had a hard time getting the DJI software assistant to show the UI for the original Phantom / Naza controls (with the P1 connected it still showed things like the P2 battery page). After repeated attempts to switch to Naza-M controls from the Phantom...
  2. J

    Phantom 2 radio in a Phantom 1?

    >> Also, since you had the futaba in the p1 before, I assume your rx type is already set in Assistant to d-bus and not traditional or ppm? Ah....I think this might be it (I completely forgot about the rx type switch). I'll check this and try again. Thanks ElGuano! :)
  3. J

    Phantom 2 radio in a Phantom 1?

    I fried my Phantom 1 remote and then replaced it with a Futaba T8J. Then when the Phantom 2 came out, I upgraded to it and moved the Futaba to the P2. The P2 and the T8J work great, but the P2 radio didn't work in the P1. I expected that swapping the P2 receiver into the same port on the P1...
  4. J

    Futaba T8J binding or RX install

    I'm trying to use my Futaba T8J in my Phantom 2. It worked great in my Phantom 1, but I'm running into problems with it in v2. I tried two install methods. The first was to bind the existing receiver to the FT8J, but I could not bind the two. Another thread here suggested that they cannot be...