Recent content by JustinP2

  1. J

    fpv with go pro 3 black on time lapse mode?

    never-mind...I figured it out. Should have done some more research on the subject before posting. Turns out it works fine with the timer set to any interval 5 seconds or above....doesn't work in 1 second or half second intervals. Thank you everyone for all your help.
  2. J

    fpv with go pro 3 black on time lapse mode?

    Anyone happen to know if there is a way to get video feed with a go pro hero 3 black (not 3+) when shooting in time lapse mode?? As soon as I press the shutter release button to start shooting my fpv monitor goes black (but I still see the text readout on screen). I am using a fat shark 250mw...
  3. J

    what type of solder to use on video tx?

    I am about to solder on my fatshark 250 mw tx to my Phantom 2 and was wondering if it makes any difference as to what type of solder I use? I have rosin-core solder in thicknesses of .022", .032" and .050". I also saw different types of solder at Radio Shack including ones without the rosin...
  4. J

    fly sight black pearl 7" monitor antenna question

    Hi, Does anyone happen to know if it is ok to swap out ONE of the rubber duck antennas on the black pearl monitor(with diversity)for a blue beam ultra circular polarized antenna and leave the second antenna on the monitor the stock rubber duck? I am curious if this will in any way not be a good...
  5. J

    Replaced Vision with Phantom 2

    Very nice setup and nice job on printing the monitor mount. I am looking at pretty much the same setup minus the ground station. How are you liking the black pearl monitor? Any concerns with it in bright sunlight? thanks
  6. J

    FPV tx power draw question

    Hello, I am about to purchase an fpv setup for my P2 . I only need it to frame up my shots for video and photos so range will be relatively short. I would prefer a lightweight 5.8 ghz video tx because I am trying to keep my Phantom weight down for handling and flight time. I am considering a...