Recent content by jonysan

  1. J

    Proud new Phantom 2 Vision owner!

    Hi Chippy, After reading that you are a member of the local Lifeboat Crew, I have complete and utter respect for you, good man. I do hope you can get a refund on your purchase, I have no ideas why technically this should happen, but it should not, can I suggest you pass the information you wrote...
  2. J

    Proud new Phantom 2 Vision owner!

    I don't know, good start though, moaning already, keep up the good work, happy new year .
  3. J

    Range

    Syotr, Looks like it's going well so far !!
  4. J

    Range

    Hi Syotr Interesting to read your message about gaining height when flying FPV. are you using the earlier non centralising throttle Tx, or the later version with the spring? With the earlier version I was giving the Phantom a bit of extra height at any time when I wasn't directly looking at it...
  5. J

    TX Connection - Newbie needs Help

    Hi just checked colours of wires in the gopro lead that i have, one Red one White red went to pin 3, and white went to pin 5 viewed from above, left to right hope that helps
  6. J

    TX Connection - Newbie needs Help

    Hi. i have the same gopro/tx set-up, and it took some time to figure out were on the five pin connector to connect the two wires from the gopro cable flip the cable connector over, so now you can see the metal connector pieces in the plastic, now fit the inverted connector as far to the right in...
  7. J

    Thottle Centering, help from forum member.

    Would like to say Thank You to "Rampage42" for sending me a throttle centering bar and spring assembly that he didn't require. fitted the parts this morning, and flew the Phantom, worked really well, for me it was easier to maintain a height when flying in FPV. parts were sent from Canada to...
  8. J

    How to power an Immersion TX

    hi I use the same Tx, and run it from the auxiliary power cable(red/black) that feeds through the front leftside blanking plug, quite a thin guage wire , but so far, so good! and I suppose a 600mw Tx draws more power than a 200mw ? Have run this set=up for past four weeks and no problems, ps...
  9. J

    Phantom Pilots in UK

    and further still, Somerset
  10. J

    Modifying throttle to central spring loaded

    Steve, thanks for that, no wonder the Naza gets tired and fly's away, it's working overtime, with no pay and no thanks!
  11. J

    Modifying throttle to central spring loaded

    Hi Rampage42, Have sent you a pm, I am in the U.K. , and I think you are in USA ? It could be a problem, in which case, thank you either way for that. p.s. he's a good bloke ! as we say in England
  12. J

    Modifying throttle to central spring loaded

    Thank you so much for the reply, that's interesting to know. I will check if I can also get the modification parts and then go with the T8J, Thanks.
  13. J

    Modifying throttle to central spring loaded

    Thanks for the reply, what I haven't been able to visualise is how the Phantom knows to hover, keep steady height, when the Throttle Stick springs back to the central position. But, i was forgetting about GPS ! So I presumed the later type radio/tx worked with a later version of software...
  14. J

    DJI Innovations Phantom, How Many Defective?

    Dear Mr Guinn, Please would you give these guys their money back, and then they can go off and buy something else. I've only just bought my Phantom, I've watched all your videos, and even joined this forum, to read and learn more. I like flying my Phantom, and thank you for bringing it to the...
  15. J

    Modifying throttle to central spring loaded

    Hi, now that I've got the video Tx and Antenna sorted out, and getting a good picture quality on the monitor. I'm enjoying using the FPV system, the only problem is when I yaw the Phantom to left or right , I either add or loose altitude. which is easy to correct when flying LOS, but I'm finding...