Is it disconnected ?my p3p threw it after a fender bender ,ribbon connector at gimbal was jocked ,looked ok but was loose ,again not a 4
Sent from my iPad using PhantomPilots
Might as well update it out of the box then you have no surprises and you understand the process a bit of a pain but ain't so bad at first I got stuck overthinking it.i don't know the s I have a p3p good luck and enjoy
Sent from my iPad using PhantomPilots
You should check battery and connections only problem is your rc screw mounts will most likely all break and dji will make your life miserable good luck rc easy to take apart 2 screws under rubber pads 2 screws each lower corners on underneath
Sent from my iPad using PhantomPilots
Use DJI prop guards they have directions after 3 try's ? They even come with lock tight on them and longer screws as well
Sent from my iPad using PhantomPilots
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.