Recent content by Johnny Chow

  1. J

    Phantom 3 to Mavic conversion - unboxing and pics

    I only need 3 if I have. The method I use. Camara attached to the top shell with the vps cable, camara cable and the sd card extension card connect. Leave the compass to the last, laying the top shell onto the main body shell slowly, inserting the vps cable go though the hole, carefully insert...
  2. J

    Phantom 3 to Mavic conversion - unboxing and pics

    Get a knife to scratch out the material and solder it
  3. J

    Phantom 3 to Mavic conversion - unboxing and pics

    After you mention, I go to the original page to double check, yes he did it other way round. The black are on the front left and back right and the with are on the front right and back left.
  4. J

    Phantom 3 to Mavic conversion - unboxing and pics

    I found it out under 1x sets installation. For p3s installation GPS need to install slightly adjust to bottom left (top she'll turn over ) . For the camara installation, the bottom shell (the bottom of the square hole) need to cuts off until reach the USB post, otherwise the camera will jack up...
  5. J

    Phantom 3 to Mavic conversion - unboxing and pics

    Just want to remind you something, Before you put anything on the body shell; 1. Get a 1mm drew bits to drew down the holes beside of the arms metal bits, also the top end body shell both side have tew holes on each side (same looking type of holes ). Before you put that metal bits in, you must...
  6. J

    Phantom 3 to Mavic conversion - unboxing and pics

    The width of the motor are now 450mm and original are 350mm.
  7. J

    Phantom 3 to Mavic conversion - unboxing and pics

    everything just like P3
  8. J

    Phantom 3 to Mavic conversion - unboxing and pics

    The hand catch on that mods
  9. J

    Mods

    Will that effect the video and photo quality?
  10. J

    P3S Barometer Problem + IMU Calibration

    Finally change that parts (the black box), problem sove.
  11. J

    Got nothing to do, so I decided to have change

    The orignal P3P without battery are 91xg The Mavic type mode case 108xg without the battery. But the good thing are the width form Center to center of the motor originally are 350mm to 450mm
  12. J

    Got nothing to do, so I decided to have change

    That P3P are May 2015