Recent content by John186

  1. J

    Flashing red light ???

    Yes to the first 3 questions, I have never upgraded firmware before, How do I go about doing this? Everything highlighted in the pic, I'm not sure about. It mentions uploading to the "main controller" ..Is that the transmitter? It would seem difficult if there appears to be no connection with...
  2. J

    Flashing red light ???

    Disconnected the receiver and the sliders are still on the right. Any ideas?
  3. J

    Flashing red light ???

    Which is the "X2 cable"? (Sorry I'm quite new to this) :oops:
  4. J

    Flashing red light ???

    I haven't upgraded the firmware. This is a new hobby for me and didn't want to mess things up. But the assistant software has been working previously.
  5. J

    Flashing red light ???

    Not sure why all the sliders are all in the right position, but moving the control sticks has no movement on the sliders. Before connecting the craft up, they are all central as in your photo.
  6. J

    Flashing red light ???

    Yes it does have a LED on the receiver module but does not light at all. The cabling looks all connected.
  7. J

    Flashing red light ???

    I held the button down for a few seconds to bind the transmitter but nothing happened.
  8. J

    Flashing red light ???

    This is the receiver in my phantom (version 1.1.1) No LED incation.
  9. J

    Flashing red light ???

    Here is the screenshot for the Assistant software. There is a CFG-ERR warning... "Configuration error, this may cause by firmware upgrade from old version.or abnormal Tx calibration. Re-calibrate your transmitter,and power cycle your controller and check all of the parameters." I have done the...
  10. J

    Flashing red light ???

    I hear the beep when I plug and unplug the USB cable. The green light is on with the blue light flashing in the Assitant software.
  11. J

    Flashing red light ???

    Yes the blue light is flashing in the bottem left corner of the screen. The drivers have loaded properly as the program has been working previously. (Device manager showing connections ok) The computer is connected via usb cable to the aircraft.
  12. J

    Flashing red light ???

    I do have a username and password. I have only needed to enter it once in the Assistant software.
  13. J

    Flashing red light ???

    The LED on the receiver module is not lit at all (regardless whether the transmitter is on or off).
  14. J

    Flashing red light ???

    Screens are the same.Both sticks are in centre but are showing all to one side in assistant and no reaction to transmitter input. The only thing that has changed is the status LED is now flashing yellow quickly.
  15. J

    Flashing red light ???

    Have done that. Followed instructions in DJI Phantom manual. no change.