Recent content by jogforfitness

I'm selling my Phantom 4 Standard. It's never been crashed and is in full working order. Always protected and cared for. Never exposed to excessive wind, rain or sub freezing temperatures. I’ve used it predominantly to fly Litchi missions. I'm looking to upgrade to a new model. Included...

Litchi iOS version 2.1.3 is released. I spot checked a few missions. Waypoint gimbal issue appears resolved.

Litchi iOS version 2.1.3 is released. I spot checked a few missions. Waypoint gimbal issue appears resolved.

I updated to version 2.1.2 iOS. Now every mission I created waypoint gimbal angle is hosed with some ridiculous value. And, even after updating a mission/gimbal angle and saving, it does not save. All was well before version 2.1.2. I regret updating. Until there is some resolution I have...

Yes. I'm experiencing the same error. This value is on every waypoint and every mission I created. I've tried uninstalling/reinstalling, updating the gimbal value (the mission saves but when reopening the mission the same errant value loads), etc. Running iPad Air 2 and iPhone 6s. At...

My reply is not a helpful one but, I tried countless ways to balance with my P4 Dubro balancer and their official balancing rod. I could not obtain consistent results. I'd put a blade on, spin, balance it if needed. Then take it off the rod, and back on again after rotating the blade a bit...

I upgraded to 700 with my P4 and tested. It was a little breezy here. I could be wrong but it felt like the P4 was a bit jerky. I refreshed the firmware and it still felt a bit jerky. So, I downgraded to the prior version, tested and it felt less jerky. I may be splitting hairs. I'll have...

Take note a new version of the Assistant 2 software was released in late December. If you're not running that version you may not see the firmware, etc. My prior version of Assistant 2 did NOT prompt me that there was an update. I read it in a forum somewhere then had to go to DJI website to...

Yes. I mailed in the RC to DJI (California). It took a month but, they sent me a new P4 RC. I used it a handful of times since (winter now so, few flying opportunities) and it's charging as it should. DJI didn't charge me.

I think a new version of Assistant 2 software came out in December. I was getting 'Cannot Load Firmware List' when trying to refresh my Mavic a few days ago. I manually had to seek the new Assistant 2 software from the DJI download page. I was not prompted by the older Assistant 2 to update...

I predominantly fly Litchi missions so, I don't really know. I was able to get out briefly today in my neighborhood and fly a very very short (maybe a minute in length) circular mission a few times. Encouraging news is I didn't notice any random jitter. This is tricky because it's sporadic...

The jitter occurs intermittently during a Litchi mission. The turns and such are all programmed.

I was recording at 1080 24 fps. The video does not have any sudden movements. I'm flying around an old steel mill at roughly 250-300 ft. I can bump up the frame rate to 30 but, I'm sensing the issue is really mechanical. My guess is it's a motor that moves the camera. Regardless, I plan to...

Never considered it could be SD card related. I will reformat to see if it makes a difference. I've been using it for a year or so now. I'm already and still recording at 1080. Transmission is set to 4mbps. Not sure when I'll get to retry as the weather is moving colder, windier and rainy...

I've seen numerous posts on this over the lifespan of the P4 but don't know if anyone has discovered a resolution. I experience shaky or jittery video (10 second video link below) often especially when the camera is facing to the left or right. This is not a filter issue as far as slowing...