This has been a fantastic thread and like others I would like to say a big thank you to Ian and all other contributors to this Phantom 2 specific profile for the 8FGS & T14SG.
I am fortunate to have the 14 and use it in combination with the DJI Lightbridge. I like the hidden forward/reverse...
Hi, it's not just your loss of the £1000 you need to worry about, you need to consider that if you do crash your £1000 investment might cause some damage to another 3rd party person or their property. We have inherited the "blame and claim" society from the USA. As soon as I purchased my...
I had same "connection broken" issue after I did the last firmware update. Tried all sorts to fix it. Checked all cable connections and still nothing with red video light still on on Airstation.
I then just pulled out the HDMI plug out of the Airstation and pushed it back in and hey presto I...
Hi,
Hope this helps - This topic has been raised before and the simple answer previously was a NO, you can't fit Lightbridge to a Vision+
However I was just having a trawl of the DJI WiKi and came across this by chance -
http://wiki.dji.com/en/index.php/Using_ ... ightbridge
It seems you can...
Hi,
You can't. You have to manually start recording by pressing the button on the camera before you take off. I have mine set to record video and take stills every 15 seconds. Stop it recording when you land.
Re: Looking for DJI Phantom2/Lightbridge/Futaba trainer in N
Hi,
If you can book me on a flight from Manchester UK, I could come over at the end of next week.
I was one of the earliest people to receive the Lightbridge here in the UK as I had it on preorder. I run Phantom 2, h3-3d, GoPro 3+...
Hi, I bought a damaged transmitter off eBay that someone had done the same and broke the pin off the small circuit board. Looking closely at your photo it looks like you have soldered the wires in the wrong place. On the board there are two longer tabs either side of a shorter one in the middle...
Hi again,
Can you post a photo of your clip on rotor guards please.
Did you make them yourself or buy them. If so where did you buy them from please?
Re the issue of cameras field of view seeing the front arms and motors I had had another idea to lower the whole camera and gimbal assembly...
Hi,
I'm new on here, only joined yesterday. I am an engineer and have had Phantoms since February and have been giving the landing gear/rotor guards a lot of thought. You obviously have the 3D printing kit to produce stuff so I will suggest my ideas.
My ideas started with the rotor guards...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.