Recent content by JGW

  1. J

    Flew the real Phantom II’s . 289 combat missions. Won’t take this forum’s time again. Thanks

    Flew the real Phantom II’s . 289 combat missions. Won’t take this forum’s time again. Thanks
  2. J

    Phantom 3 4k gimbal not working and no image

    P3 4K.. Gimbal doesn’t full travel. Connections all appear OK. Will the typical “rebuild” kits advisable assuming a mechanical issue?
  3. J

    What to do with a Phantom 4 and nothing else....

    Thank you for your reply. I guess I give them too much cyber credit.
  4. J

    What to do with a Phantom 4 and nothing else....

    Not really a reply but similar question just from the other side...if you lose your new DJI or it’s USED by some else, after the ac is activated and firmware downloaded, can or will DJI assist in identifying it afterward by the identification that they may have on it based on retailer sales...
  5. J

    No Link Button on my P3 4K

    Revisiting the thread a bit later....never got the remote synced with the a/c. After replacing the main board with a new one supposedly for the 4K brings the question, did I really receive the correct board and/or processor? Saw many comments on line and from those selling the DJI parts that the...
  6. J

    No Link Button on my P3 4K

    Sounding a bit foolish, I recall when I received it new, the battery would not eject and stayed jammed inside. I requested return and sent it back to DJI. I received a replacement thereafter but realized it was the same unit. Apparently, they replaced the lower shell and it only had the two...
  7. J

    No Link Button on my P3 4K

  8. J

    No Link Button on my P3 4K

    There is no other opening on the entire aircraft other than the two I mentioned.
  9. J

    No Link Button on my P3 4K

    After two weeks of coping with the dreaded RC Lost syndrome and watching videos galore about how to resync the remote to the aircraft I come hat in hand to ask the experts how to do it. There is NO sync button or opening on my P34K except the two small ports ( holes). The one on the left where...
  10. J

    Controller won’t sync with aircraft p3 4K

    A bit different...after minor ribbon cable damage, I replaced P3 4K board with the same board part as before. Pretty confident on installation...one of the damaged cables came from the GPS module . I ordered a module from EBAY for Phantom 3 standard as seller stated it was the same as original...