Yay, great to see you spotted the fix for this issue as well. I made a video and posted a thread so that more people stop sending their gear back to DJI for repair -
Just need to remind people that the arm needs to be slid up a fraction so that it's not touching anything but the yaw motor...
Just a quick 5 sec fix for the buzzing gimbal issue. As shown in the middle of the video there is a small grub screw that needs tightening (ensuring the arm attached to the yaw motor shaft it clear of the top and bottom braces before you tighten it as it can slide to the bottom and actually...
Bum, even with the controller in NAZA mode the gimbal settings are not exposed to the end user. The NAZA software won't recognise that controller even though it is in NAZA mode. Hope they can come up with a fix for this via software soon?
Starting to think that I should consider changing the Phantom to NAZA-M mode and see if I can set the gimbal servo travel centre value on roll to correct the level?
Nothing appears to be bent. My Phantom is only a week old and has never been dropped or had any bad landings. I can clearly see the flat edge of the shaft is not in line with the horizontal lines of the camera so this is a manufacturing issue, however it is minor enough to warrant changing the...
I also have the same issue but to a smaller extent. The roll is out by about 3-5 deg and is more an irritation than a big issue. I would however like to fix it the same way as shown in the earlier video by grasping the roll shaft with pliers and twisting. However I have a newer model than the...
Just a little something omitted from the latest manual - it doesn't indicate if you need the power switch on the transmitter (V3) turned on or off while charging with the USB cable? If I have the power switch on, the four LED's cycle up repeatedly which seems to indicate that it is charging...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.