Recent content by Jason1823

Do you run the stock gimble or do you use a gopro?

No Problem. FYI I got a couple aftermarket batterys for the phantom and I took one apart and the wiring is completely different than an oem one so not sure if you can change the cells on an aftermarket. Have fun flying and if you want to have some real fun you should enable naze-m mode in the...

I'd rather be flying ;)

Here is the form i used for instructions. Phantom 2 battery mod - use any lipo with your p2! - RC Groups i followed this sorta i just mounted the battery board on the side of the drone instead and sawed the battery cap so it holds the lipo in the drone. The wiring is a little difficult and i...

To get the top of the battery off its just a matter of getting a screw driver under the clips and working your way around that battery. FYI it will pretty much break a couple of the clips every time. Also if your interested it is possible to resolder the battery management board with a couple...

If you hold down on the power button for like 10 sec it will start blinking and it will tell you the battery health. The power button will blink and if the battery is good all four lights will be solid. Also how bad where the battery’s when you pulled them out. Would they power on?

Weird. So the battery does power on but the capacity is at zero. I think it might have something to do with the battery board thinks the batteries are dead. Will the drone fly with the error?

I agree my older battery’s on my P2 were tight because they were slightly swollen.

Hi I did this mod and you have to charge your battery using the standard DJI charger through the smart board. The smart board knows how much power has been used and if you charge with a different charger the board will still show the battery as being low on power. Also the p2 battery gauge is...

The P2 is a 3s system while the P3 is a 4S so a 3s is 11.1v 4s is around 14.3v.

I just did the mod on my phantom 2 try charging the cells using a standard Lipo charger and get the cells around 3.8 volts or something around there. Then try the DJI charger. FYI once you get the board trained to the new cells only charge using DJI charger or the smart battery will think the...

Mine did that, ended up being a cracked gps antenna. Very easy fix.