Recent content by J__F

finally had some time to get stuck into this - i have removed the cooling fan on the 352 with room to re connect if needed. im still abit hesitant to fly with it as the tx gets very hot to the touch i can feel the heat up through the body of the phantom if i remove the phantom battery - (could...

thanks hrosee that might be the best short term solution i will just remove the fan and leave the heatsink I was thinking the immersionRC 600mW aswell I have the storm " fpv easy combo" from helipal http://www.helipal.com/storm-all-in-one ... -easy.html which included a monitor with...

interesting.. i just found a blurb on the boscam 400MW transmitter - "Features: FPV 5.8G 400mW AV transmitting module, a wonderful choice for avoiding interference for who using 2.4G radio system Dimension and weight is similar to 200mw TX, yet the range is extended. Compare to the 500mw...

I've just noticed on my fpv transmitter (Boscam352 attached to the phantom body behind the gimbal with 3M dual lock tape) as soon as it powers up, the cooling fan on it is vibrating constantly - small vibrations but enough to feel it through the body of the phantom2.. anything to worry about...

Re: DJI 5.8Ghz Cloverleaf Antenna vs IBCrazy 5.8GHz Bluebeam Hi Tony sounds good to me! pm'd you with some details cheers John

Re: DJI 5.8Ghz Cloverleaf Antenna vs IBCrazy 5.8GHz Bluebeam thanks guys appreciate the info can anyone advise if there is a performance difference in these two or is it purely cosmetic? one has the shielding running the length of the aerial and one has it at the ends - they are both...

hi there just after some thoughts from anyone with experience with either of these two? which would be preferred for use with a boscam TS352 (storm 'easy' combo) on a phantom 2 with h3-3d cheers John

pic attached

thanks bmews appreciate the reply - I have the noticed TBE and j hooking when flying since day one and I'm learning to adjust flying technique to compensate - I've been following the forums here re the beta testing. this wobble didn't seem to look like any of the tbe jhooking vids I've seen but...

takeoff was from an open grass field flat average auckland overcast day slight breeze - started up motors as normal, gps had 9 sattelites as soon as it was off the ground instant wobble side to side - front to back. quickly bought it back down checked props, gimbal, controller etc nothing looked...

Hi there today for the first time i had an intense wobble when hovering and flying in gps mode. (Phantom 2 with h3-3d and go pro black approx 4weeks old) before the flight i had adjusted the tilt speed on the gimbal from 50 down to 2. would making this adjustment affected the stability at all...

cheers guys appreciate the replies - the 2 pins and base plate are all installed as per dji instructions, I think leaving the front pin in place and removing the rear pin and replacing it with a thin cable tie sounds like the best fix

Hi there I've recently purchased a phantom 2 with h3 - 3d gimbal using a hero3+ black I've noticed the gimbal once powered up with hit the rear plastic locking pin with panning motion - sometimes even jamming up against it, is there a safe/recommended fix or alternative to these pins? cheers John