Recent content by IrMarky

  1. I

    Low Voltage Warnings?

    The throttle sticks are spring loaded so in the middle is always hover, and it hovers nicely in the middle. The engines are not rough to turn at all, they all seem exactly the same turning wise. I have replaced the props and will give it another try tomorrow, if no luck then I will contact...
  2. I

    Low Voltage Warnings?

    Oh right, so even a tiny chip will cause these low voltage warnings?!
  3. I

    Low Voltage Warnings?

    These flashing red lights are defiantly not a GPS issue because the phantom automatically lands its self, its defiantly a 'low voltage warning' according to the manual anyway... When I do the compass dance I don't reset the Phantom, I just let it sit for a few minutes while it acquires a home...
  4. I

    Low Voltage Warnings?

    Okay, so with a new battery and the old battery I tried removing the blades and powering it up, full throttle with stock settings on the voltage protection.... NO FLASHING RED LIGHTS! so this means that something must be wrong when it's off the ground and the blades are spinning? could it be a...
  5. I

    Low Voltage Warnings?

    I have nothing attached, no extra weight at all. What do you mean buy the default file? will this mess up any settings? where can I find this? Thank you :)
  6. I

    Low Voltage Warnings?

    That is correct, fully charged around 12.6V. I have done the compass dance but again seconds after take off I have the battery low warning and the Phantom automatically lands. If I lower the first and second level voltages in the smart system, I will get a lot more airtime, but I know I...
  7. I

    Low Voltage Warnings?

    UPDATE: Voltage meter has arrived. Here are the results: Voltage: 12.3V Cell 1: 4.05 Cell 2: 4.12 Cell 3: 4.17
  8. I

    New to Phantom, question??

    mine does not go through the warm up process either, when charging the camera will blink red and will be solid red when charged. :D :D
  9. I

    Low Voltage Warnings?

    Thank you dude... I will buy a voltage reader and new battery.. will let you know the outcome.
  10. I

    Low Voltage Warnings?

    Hi, I just have the FC40's camera mount attached, nothing else. I have not attached the camera yet... I will order a new battery this week and see if that makes a difference... When checking the voltage with that meter, what should I be looking out for, if I have a dead cell. Thank you in...
  11. I

    Low Voltage Warnings?

    Hi, If I charge on 3A the battery will charge then the cells will balance for hours, although if I switch to 2A the battery will fully charge and balance within 2 hours. Could this be another sign of a defective battery? Can I use this voltage checker? http://www.heliguy.com/Extras/RC-Helico...
  12. I

    Low Voltage Warnings?

    Hi, That is correct, at full charge it is about 12.5V.
  13. I

    Low Voltage Warnings?

    Hi, I don't have anything to take the voltage reading other than what appears on the assistant software. (Current Voltage X3) The image above are the stock settings that warn me 5 seconds after take off of a low battery, somebody told me to lower these settings to First Level - 11.10V and...
  14. I

    Low Voltage Warnings?

    Hello, Recently I purchased the Phantom FC40. Upon take off on a fully charged battery, the low voltage warning LED's kicked in 5 seconds after take-off, the Phantom automatically landed. Here are the stock settings: After I adjusted the stock settings to First Level - 11.10V and Second...
See more