Recent content by HyruleJedi86

I'm going to call this tentatively fixed. I had to remove some metal on the new arm that was installed right by that motor because I think it was rubbing. I polished it up and put it all back together and did a test flight. It ran normally but I'll see what happens tomorrow since I'm flying...

No but I'm starting to think the new part is rubbing causing the motor to bind up. I'm taking away some material on the new arm and I'm slowly noticing the camera can be moved easier and easier the more I do. Sent from my XT1585 using Tapatalk

Ok, I just checked the settings and it's set to follow.

So, I was unaware that the DJI app even had an FPV option and I've never used follow me so I don't think they are enabled. I uploaded this video to youtube that I just took. This is me flying the P3A in my front yard only moving left and right. You can see what's happening, or rather what's not...

I watched the video and it looks like not much applies to me in that video, the motor spins smoothly, I don't see anything in it cruding it up. I can't take it apart, where he epoxies the shaft back in mine isn't loose. I am getting some movement on the yaw motor but it's acting like it's...

Alright, It doesn't seem to have made a difference. I checked the connections, tried gimbal calibration and manual roll adjust but the motor just doesn't move. I just noticed thought that just after a minute or two of testing the motor got pretty warm. Thoughts?

OK, I will give that a try. Thanks! Sent from my XT1585 using Tapatalk

It's just the one motor and when I tried that fix in the video I unplugged the cables looked them over and made sure when I put them back that they were all the way in. I don't see any damage to them. I don't know how to check and see if there is unseen damage to the cable or the motor is just...

I actually found that video and tried that fix. Mine is aligned correctly. It seems the motor isnt working at all but it's hard to say for sure. I know that it isn't self leveling during flight. Sent from my XT1585 using Tapatalk

Hey All, long time reader. I need some help so I can trouble shoot a problem Unfortunatly, I crashed in a gym by hitting a rafter and the drone falling straight down. The legs took most of the impact but the yaw arm broke. I bought a replaement and replacement legs. Installed the new yaw arm and...

Grafton, Ohio Lorain county here Sent from my XT1585 using Tapatalk

How does this look for an FPV headset to go along with the HDMI module on the phantom series? Quanum Fatshark Genesis HD FPV Goggle w/ integrated 40 CH 5.8ghz Diversity Receiver

Found it I think you can do it the way in the other video but this seems easier and less likely to have lag. Sent from my XT1585 using Tapatalk

I thought you could. I found a video on YouTube that showed that. I'll see if I can find it. It was my impression that with the settings setup correctly the fatshark would only show the video and some stats like battery, height, distance and signal, etc. But the tablet or phone connected...

The way I understand it is if you buy the HDMI module for the remote controller you can plug your shield into the USB and the fatshark into the hdmi port. Then you have the normal controls available to you on the shield but fpv with your signal strength, battery life and other stats available on...