I ran into the same problem. Trick i used was take a wrench socket ( i used a 5/8) to hold the motor & then i used an 1/8 " tungsten rod ( anything metal) to drive the sob out. I did set the new bearings in the case & seat them with a c clamp tho very slowly.. Side note : depending on bearing...
Yes it is PNP came w/ factory loom only cut the plug off to match battery. Everything so far has been checked as to channels even tried scrolling to see if freq was different from listed #.. & nothing .camera gets warm tho..thanks pete
Hello pilots. Stupid question just bought a Sony fpv system (http://www.hobbyking.com/hobbyking/stor ... duct=13442)
Hooked it up &Got js out of it. Tried it on several monitors & still jack. Any ideas as I'm stumped. I have the right voltage to both RX& tx .everything powers up but no image...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.