Looks like, as you posted already that there must be some kind of homing, but not sure how that's done?
Bought a broken gimbal off ebay, replaced the board and motor of my gimbal with the one off ebay and now it works.
Anyone here ever just replaced the yaw-arm motor successfully?
Sent from...
Replaced the yaw-motor, and now gimbal only moves between center and far left. As you pointed out, the magnet might be screwed up or missing.
Any procedures or Pictures which might point me into the right direction on how to align the magnets?
Thanks
Same issue here.
Crashed P3S, tightened the hex screw but cam points to right.
Did IMU-CAL and gimbal-calibration, but that didn't help.
Well,
Noticed my yaw-arm is bent.
So some of you might want to check that as well.
Cost for replacement: between $5 and $50 on ebay or amazon.
Casted...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.