Recent content by H-Films

Thanks N017RW! Yes, That's what I was thinking about. After some google research I've confirmed that all naza ports deliver 5v on the center pin and ground on the upper pin but I don't know if there's enough current to feed the gopro. I think that at least, I wont fry the camera but what would...

LOL! I did it too several times on different electronic gadgets (like my gopro) and I even start getting angry when they don't turn on until I remember that they are not the bird.

Hey Driffill, nice finding! It looks like you're right since the power cable end has a 3 pin layout but only the top and middle one are actually wired (red/positive at the middle and black/negative on top). So, are you sure I won't burn my gopro if I power it through the F1 port? Thank you...

I have two phantoms 2v+ and I have the exact same problem on both quads after the firmware upgrade. I've tried reducing the gains like RCblog.nl but had no luck, it still dances in the air like an old washer machine. Any other possible solution? Thanks!

Lol... I'm not sure yet!

Hello everybody! Some months ago, I've had the exact same problem. I was flying my p2v+ (80%+ battery) and when I was bringing it down to land, and when it was about 7 or 8 meters from the ground (23/24 feet) it suddenly lost power, props stopped (no sound, complete silence) and then it...

Hey, Check out this thread: http://www.rcgroups.com/forums/showthre ... 815&page=4 it seems that it is possible to get the video from your gopro and send it to you vision plus app without using the crapy and extremely weak vision plus camera/gimbal. It would save you some money since you don't...