Recent content by Gold333

  1. G

    Phantom 1.1.1. Gimbal lever won't register in Naza

    I have calibrated the Tx in the following ways: 1. Standalone Tx calibration: Hold both sticks up, THEN switch on, wait for double tone, etc. 2. Calibration using NAZA V2 Assistant software Doing both of these steps DOES NOT ALLOW the Gimbal lever to detect motion in the NAZA V2 Assistant...
  2. G

    Phantom 1.1.1. Gimbal lever won't register in Naza

    I thought the 1.1.1. featured the upgrade board as it has a working (working, except on mine) X1 gimbal axis stick behind the controller. EDIT: So now someone is saying that until I run the RX Assistant 1.1 (the software assistant that requires you to dismantle the Tx and hook it to the PC...
  3. G

    Phantom 1.1.1. Gimbal lever won't register in Naza

    The 1.1.1. has a gimbal switch on the TX. The first screenshot is from a P1. Thank you for your Tx calibration instructions, unfortunately they are not the right version and do not work with the 1.1.1. Tx which has a spring loaded throttle stick unlike the previous versions. EDIT: But I...
  4. G

    Phantom 1.1.1. Gimbal lever won't register in Naza

    I have the Phantom 1.1.1. I'm sure the little gimbal lever is turning the potentiometer in the TX. However in the Naza software there is no Gimbal information (IMU or CMU): Like this screenshot of another user shows: Mine just shows: Also the Gimbal calibration in Naza under Basic -->...