Recent content by goinup

  1. goinup

    Nvidia Shield KI settings.

    Try clearing the cache on the app you're using (e.g., DJI GO)
  2. goinup

    Nvidia Shield KI settings.

    Unfortunately, Nvidia stopped updating, and discontinued the Shield K1 Tablet sometime after 2016, in favor of a desktop gaming device. It's soft/firm ware is no longer compatible w/advances to DJI GO, Litchi, etc. Having been the proud owner of this top dog DJI drone monitor, I sadly found...
  3. goinup

    Log in DJI Go app

    The verification code is usually sent to you via your DJI registered email address or cell phone.
  4. goinup

    Can I install a mini winch to my Phantom 4 pro?

    Keep in mind that all DJI Drones are designed to provide consistent lift and stability to that drone's weight. Anything you attach, or try to lift creates drag, which exponentially adds additional weight, on the drones flight and puts un-designed strain on your motors and the craft's stability.
  5. goinup

    Phantom 4 advanced battery problems or something else?

    Suggest you do as DJI advised, refresh the firmware and calibrate IMU. If the problem persists, purchase new battery.
  6. goinup

    Roof Spray Project

    Well, there's this consideration: We"pilots" should keep in mind that DJI and all other drone manufacturers designed hobby drone motors to provide lift and motion for the weight and air resistance of that drone for it's intended maneuvers. Drone" Payload AirDrop Release" devices, when...
  7. goinup

    P3A - so how do you shut down in an emergency?

    Only if it's stuck in a tree/cell tower, etc. Otherwise, it will just fall down and go "Boom", resulting in a conversation starting paper weight ;-)
  8. goinup

    P4P No video (disconnected) and iPad message says "not charging"

    Change your controller to pad cable. Always use the cable that came w/your monitoring device (Pad/phone).
  9. goinup

    Phantom 3 pro

    You may want to borrow someone else's newer IPad Mini, and check to see if your mini is the problem. Many DJI Firmware upgrades are beyond the capability of vintage pads and tablets (E.g., NVIDIA K1).
  10. goinup

    Litchi shut down mid mission.

    Sounds like a problem w/in-drone circuitry. I suggest sending it in to a DJI approved repair facility near you for evaluation.
  11. goinup

    Litchi shut down mid mission.

    Once you upload your Litchi mission, it's guiding the craft. You can set your controller down and drink a brew. You said your could "hear the motors, but it was not moving" Highly unlikely unless you had visual. It is common, not uncommon to lose signal on long missions due to line-of-sight...
  12. goinup

    here’s something you don’t see every day

    Innovative, clever, Imaginative - lots of professionalism -and yes, FUNNY~!
  13. goinup

    weird marks on props

    I believe you will discover that's the manufacturer's direction "carrot"of how to attach that prop to a motor.
  14. goinup

    Armed Drone in my Backyard Recently

    Back when cattle was a lucrative business, prized bulls were shipped to buyers throughout the U.S.. I note there seems to be a resurgence of bull-shipping lately......
  15. goinup

    Question About Using Filters for a Night Time Shoot

    Just keep the ND filter on that came w/your bird. Any desired lighting corrections can be accomplished via manual camera settings and your photo/video software.