Hi I am a Pilot as well as a Drone user, the flying rule states not to fly below 400ft unless approaching to land or takeoff. One exception is training for engine failure (single engine aircraft). where you select a field and approach but again the 400ft rule should not be broken.
So this...
I have purchased a compatible 5400mAh battery with screen on front via eBay. After charging it suddenly gave an error ERR2 its showing 7.47v and 4443mAh. Doesn't power the P2V+ ant ideas? Or have I purchased a duff unit?
Purchased a P2V+ Camera off eBay to repair and use if possible on my PV2+ can someone tell me the cause/possible repair for the camera "Twitch" only in the horizontal plane? As far as I know the ribbon cable is good and I have levelled the camera vertically on its poti on the circuit which...
Sorry, left this post on wrong forum, I have a P2V+ and i have disconnected the gimbal/camera from the Phantom. I now understand on the P2V+ this will disconnect the power feed to the Wifi module hence it will not function. Reconnected the gimbal connections and the Wifi now transmits...
Update Mako79, thanks reconnected the camera/gimbal with the three grey wires and bingo I have the Wifi 60:60:1f xxx now showing on the Android App. So this checks out the Wifi as working. Now to investigate why the camera is not seen.
Thai may be down to a bum new ribbon cable. I have...
Oh and I have obviously just got a P2V+ which has crashed, bird fly's and replaced Camera ribbon. Get Red light on Gimbal and was trying to check Wifi as above
I am analysing a problem with my Wifi can someone tell me, if you disconnect the camera / Gimbal from the bird should you still be able to connect to the Phantom via Extender on Vision App? I get msg "Phantom connect broken" although I have supposedly bound the extender as it come up with...
Now for a question about Wifi, if the camera is disconnected physically can you still see and connect to the Phantom ? At present using an iPad I only see the extender Wifi and when I start the Vision App it says can't connect to Phantom.
By the way the MAC code for the Phantom Wifi is also...
Thanks for reply, ribbon cable was from eBay UK sourced looked good with firm connectors. When you say main board I assume you are referring to the PCB in the Gimbal case?
I have obtained a crashed P3V+. The bird flies OK after battery was charged and radio re-sync. The Gimbal had come apart and the ribbon cable broken, replaced but all I get is a constant Red Light no gimbal movement. Checked the connectors all in firmly, so it may be the Gimbal PCB which...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.