Recent content by Frogdodger

So it's as easy as that? Just mailing it to someone that lives there?

What about disassembling the drone and sticking it is your checked bag under the plane? Sounds like a pain in the butt, but that could work. Take the props off and the landing gear and any other things that can easily come off.. and scatter them in different areas of the suitcase... :)

I would love to see the inspire in action!

I'm near Fry and Morton. We are close.

Marg2, I'm in West Houston, near Katy..

Thanks for the feedback everyone! Looks like I have a few things to try out to see if it's just the area I'm in. I'm going to try and take it out into the country today, I'll let ya know the results.

Here's my flight log. You can see I don't get very far before I lose signal.

Hey sir, I did all the calibrations. I'm in the suburbs. Should it go further than it is?

Maverick, I have seen that and I also turned off the beginner mode which turns off the range limits.

*very far

I bought my P3S about 2 weeks ago and I can seem to go vertical far with it before my remote says signal weak, and then I lose signal. What is the average distance that a P3S is supposed to get right out of the box with no mods? I live in Houston, not sure if that help. I can usually not get it...

Gary, that split on the top is normal? What's the best way you reseat it?

Thanks for the quick response! Next question is do you have to remove the whole camera assembly to remove the pins just to replace the absorber balls?

Can someone PLEASE tell me how to go about replacing these anti vibration balls. I have one that seems to be broken and it's causing the camera to tilt. Any help would be much appreciated! It's the rear ball with the locking pin attached.