I ripped out the compass connector soldered to the main board on my P3 pro while separating the stupidly difficult shell halves.. $400 later... I have a board bought from Dark Energy Drones ready to install. Should I swap the micro SD card underneath with the one from my original P3?? What...
I want to solder in a led headlight to my front LED's so I can turn it on and off via the TX.. what does the "VCC" stand for that the red LED wire is soldered to on the main board? Any better ideas? Thanks
Scott
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.