Recent content by Foxxer

Ok, have FINALLY getting my lightbridge to work, futaba to work (all as a newb) I flew and got some nice shots. However, all of a sudden the P2 veered down fast into the ground suddenly, as if a prop went out of balanced. My gimble was destroyed, gopro destroyed and P2 beaten badly and the...

Ok, have FINALLY getting my lightbridge to work, futaba to work (all as a newb) I flew and got some nice shots. However, all of a sudden the P2 veered down fast into the ground suddenly, as if a prop went out of balanced. My gimble was destroyed, gopro destroyed and P2 beaten badly and the...

this was VERY helpful. I got it working following that exactly. I used that guys model to import into the Futaba which worked. However the P2 crashed and pretty muched smashed my gimble, P2 and broke the lightbridge wires. It was flying fine until then suddenly it veeered off and down by itself.

yes its connected. I get FPV out in HD. The gimble works to tilt. I assume you are not talking about the light under the phantom which is used to bind to a controller? I dont use that due to the lightbridge and i am wired directly to the lightbridge via a trainer cable.

Hi not sure what you mean by CSC? I did the lightbridge calibration and the phantom 2 calibration. Which manual did you follow exactly, did you connect the Futaba 14SG to the P2 with a lightbridge?

Thxs for the reply. 1) the lightbridge is connected. I have been able to see the video output. The link is green and I can move the camera up and down from the futaba. 2) I have used the calibration software and its a little confusing. Actually it's very confusing. The videos out there on...

I am a pilot in real life (http://www.facebook.com/CirrusPilot) but a total newb to Phantoms. Last Friday I bought a Phantom 2, Lightbridge etc from a dealer in San Jose CA. Without the lightbridge it flew fine. I then installed the lightbridge after watching videos online and the trouble...