Recent content by Firecracker-P3

I have had a phantom 3 standard for a long time, and only now every time I try to fly does the same error happen, I turn on the drone control and connect to the DJIgo application successfully, but after about a minute.... the drone disconnects, however in the application, aircraft disconnected...

Thanks, @RodPad I sent it to Dji under warranty Not sure what all they replaced

Recalibrated IMU (3x) Tried to calibrate compass 5x or more in open areas....nothing within 100 yards of me Still...will not calibrate Looking at the sensor data in a he Dji GO app, the compass is all 0's It is common for the compass/gps module to fail? Sent from my iPhone using PhantomPilots

You'll have to removed the top half of the shell. Youtube has some videos explaining how to do it. Fairly simple

Sounds like the connection for the GPS may have come off at the circuit board. Especially if it crashed.

Correction....Compass Calibration

Did that, too

So, I've got 57 total flights on my P3S. This morning, I was videoing my son driving his little rc buggy (I've done it numerous times) when the aircraft drifted significantly and struck a bush then my garage door. It inverted and crashed on the driveway upside down. When it began drifting, I...

That was luck. Glad there wasn't any more damage. Were you using Litchi?

Where is that post? I'd love to read it

I'm calling y agent tomorrow

I'll have to look up the HS RC club. I'm right here in Benton

I've not gotten that follow me mode to work yet! Just keeps saying not enough goes signal

Central Arkansas here. Benton\Bryant area

Look at the water splashing. Looks to be close to the correct speed Sent from my iPad using PhantomPilots