Recent content by Ff_emt2008

Also i have two airports one is like 4.8 miles away and one is like 4 miles away and they dont have towers. Do i still have to call before flying. To be safe i have been staying under 100 feet for know but want to go higher.

Got my p2 in the air today mith my gopro 3 on it did great till i hit a tree and got stuck. Good news, No damage

So i got the phantom in the air today was flying a lot better it did a lot better job hovering. I did put it in fly home mode and all it did was fly up and hover so got to look into that. Because i have a small flight limit set i took it out of gps mode to have more flight room and the wind help...

Thats y im not putting my 4 on lol

I heated the a heat gun on low and just bent it with my hands

After some research im almost sure my gain was all wrong. My buddy that owned it before me had more weight on it then i did so i think it just had to much vertical gain so i changed that. He is also very handy with the phantoms and im very handy with electronics so im sure the two of use will...

That is my gopro 3. After my first flight/crash i dont want my 4 on there and dor now yes no gimbal but i do have one

All i had to do was replace the after market landing gear and i bent one arm. New landing gear and a heat gun its ready to fly

Mine took two hard falls with only minor damage. They built a great drone

Hey everyone i am new here and have only been put flying my phantom 2 once and it didnt go all that well. I got it 2nd hand and made sure everything was calibrated for flight. Took it out and took off for first flight. It took right off and felt like i had no control and it came crashing down...

There is a lot of skill when it comes to soldering those who say there isnt i bet gets a lot of cold solder and would let go with very little heat added to it. I have 10 plus years doing soldering and the last 3 doing it on navy ships