Recent content by Faze82

yeah no way I'm able to fix that :( it just irritates me because it was working properly, I might have shorten the board while disassembling the gimbal to replace the motor :(

oh, right :) [00016991]========== remo-con disconnect. boot(15) ============ [00017126]Firmware [C:\DM368Fw.bin] detected, card sn [0x70ce2a83]. [00017160][08 00] Firmware upgrade start... [00521043][08 00] Firmware upgrade finished successfully. [00521083]Done. [00014593]==========...

I did it, the only thing in the logs was: ========== 2014.01.01 00:00:14 remo-con disconnect====== Packet: P3X_FW_V01.02.0006.bin Result: Failed. Reboot the aircraft and try to upgrade the firmware again.

It's a PRO. I am not sure what you mean by flat foam wire. So you mean basically downgrade the firmware? I did not update it at all after the motor replacement though

anyone? :/

I replaced the yaw motor last week and put the gimbal back together. Now when I start the drone, I do not see any image on the screen of my phone. Gimbal/camer seems to work, there is no error message. I tried to take pictures and it works, they are stored on the SD card. But the video feed is...

wow if I'm ever in the area I will, I am in Boca.. Will try to fix it, will see what happens lol.. thank you!

wow that sounds cool... I have 3 yaw motors now so I might try it myself.. are you in Florida too? Where?

I don't follow, how will you know the position after you take it apart? I understand what you mean, mark the magnet when the drone is turned off and adjust the shaft and the magnet. Is the magnet what indicates the position of the shaft for the drone?

That's exactly what I was actually thinking to do... Just to rotate it a little.. but I'm pretty scared that the little srew wont hold it as good as on the flat. The motors were both new. When I put the other motor in, the camera stays to right side instead of left as with the othe motor..

anyone?

yes I calibrated the IMU, gimbal and the remote, no change. It definitely looks like it's couple of degrees off, gimbal is fine it performs correctly on all the axis, it's just off to one side :(

Hi, did anyone replace the yaw motor on P3? It should be the same for all (Pro, Std, Adv) I have one P3Pro, the gimbal circuit board was burned, so I replaced it with another one. But, the camera is leaning to the side (not tilted, leaning on the yaw axis). I thought it might be caused by the...