Recent content by Faheem

thanks for the warning, perhaps I should revert to iOS9 again for now till its sorted. That said, i tested a iOS9 device posted popups to check and then plugged my iOS10 device back in and popup was magically gone.

No probs and good luck. So until apple does an update and the bug is fixed, I guess the popup is there to stay

I have the same issue, I by default have the C1 button assign to camera "down/up" and the C2 button I have left it to whatever the default was. To temporary remedy the popup, I assigned the C2 button to camera "down/up" with no probs at all.

Thats my thinking too, before my iOS10 update there was no issue but now I have the same prob.

nope, it keeps popping up after i press allow >_<

Hey guys. I have set my C1 button to camera down/forward. Every time I click the C1 button now on my P3 Pro RC I receive an iOS popup with the message "DJI GO would like to communicate with the DJI C1". The action still works but the popup requires me to manual 'Allow' or 'Ignore'. The popup...

When i switch my TK-102 tracker unit on, I get multiple smses with its location. This would use up my data on the tracker sim in no time. I followed the instructions to cancel autotrack, I sms "notn+password" (notn plus my password) to the tracker number and keep getting a "command Error!"...

When i switch my TK-102 tracker unit on, I get multiple smses with its location. This would use up my data on the tracker sim in no time. I followed the instructions to cancel autotrack, I sms "notn+password" (notn plus my password) to the tracker number and keep getting a "command Error!"...

When i switch my TK-102 tracker unit on, I get multiple smses with its location. This would use up my data on the tracker sim in no time. I followed the instructions to cancel autotrack, I sms "notn+password" (notn plus my password) to the tracker number and keep getting a "command Error!"...

Will give the various options a try and see what works best :) thanks

That could be it hey. I haven't tried switching it on with the tracker attached to the camera gimbal. Will give this shot. Watch this space :)

The TK-102 is the smallest I could find here in SA. Unless you have 1 modified and fitted inside your drone and connect it to the power supply of the drone?

It is fairly central on the rear of the gimbal, my initial question was if this would negatively effect the gimbal operation. Why I'm asking this is because when i switch my P3P on with the gimbal guard still attached, i get a message about gimbal being overloaded or something like that and the...

Correct, it is. I checked out that option as well. There is not enough surface for mounting.

Thanks @Jussaguy I'll give it a try then and see what happens :)